PREMISE PRO INSECTICIDE
ENVIRONMENTAL SCIENCE U.S., LLC · Imidacloprid 42.8% · EPA Reg 101563-115 · INSECTICIDE; TERMITICIDE
Document last checked 2024-06-03
About this product
Active ingredient
Imidacloprid 42.8%
Manufacturer
ENVIRONMENTAL SCIENCE U.S., LLC
Category
INSECTICIDE; TERMITICIDE
Full details for PREMISE PRO INSECTICIDE
Applicator discussion
Nothing here is label direction — the label is the law.
These are notes from other applicators, moderated before they appear.
Check the labeling accompanying the product and applicable state requirements.
According to the label From the product label
These details were extracted from this product's label PDF.
The label is the law.
Confirm every rate, site, restriction and safety requirement against the label before mixing or applying.
Check for a
state supplemental label; a product may be restricted or prohibited in a state or site even when a rate appears below.
·
EPA registration data for Reg. 101563-115 →
This product is a liquid formulation used to control subterranean termites. It is applied outdoors via a low-pressure spray to soil, foundation perimeters (through trenching or rodding), around plumbing and utility penetrations, and into voids in hollow masonry units.
Pests covered (15)
subterranean termiteDAMPWOOD TERMITESDRYWOOD TERMITESSUBTERRANEAN TERMITESANTSCARPENTER ANTSCARPENTER BEEWHARFBORERBARK BEETLESAMBROSIA BEETLESPOWDERPOST BEETLESANOBIID BEETLESDEATHWATCH BEETLEOLD HOUSE BORERWOOD INFESTING INSECTS
Areas treatable (15)
soilsoil (if fill under slab is gravel or other coarse aggregate)critical areas such as along the inside of foundation walls, and around plumbing, bath traps, utility services, and other features that will penetrate the slabfoundation perimeter (trenching/rodding)voids in hollow masonry unitsBUILDINGS (NONAGRICULTURAL) (PERIMETER) (SOIL TREATMENT)BUILDING FOUNDATIONS (SOIL TREATMENT)UTILITY AREASWOOD SURFACESBASEMENTSPLUMBING INSTALLATIONSDOMESTIC DWELLINGS (INDOOR) (WALL VOIDS)DOMESTIC DWELLINGS (OUTDOOR)DOMESTIC DWELLINGS (PERIMETER SOIL TREATMENT)CONCRETE SLABS (SOIL CONTACT NONFUMIGATION TREATMENT)
How to treat each type of area 5
soil
| Target pest |
Location |
Rate |
Unit |
Dilution |
Label notes |
| subterranean termite |
Outdoor |
1 gallon |
10 square feet |
0.05% to 0.1% |
Generally a 0.05% dilution is used for typical control situations. Where severe or persistent infestations occur a 0.1% dilution may be used. |
soil (if fill under slab is gravel or other coarse aggregate)
| Target pest |
Location |
Rate |
Unit |
Dilution |
| subterranean termite |
Outdoor |
1.5 gallons |
10 square feet |
0.05% to 0.1% |
critical areas such as along the inside of foundation walls, and around plumbing, bath traps, utility services, and other features that will penetrate the slab
| Target pest |
Location |
Rate |
Unit |
Dilution |
| subterranean termite |
Outdoor |
4 gallons |
10 linear feet |
0.05% to 0.1% |
foundation perimeter (trenching/rodding)
| Target pest |
Location |
Rate |
Unit |
Dilution |
Label notes |
| subterranean termite |
Outdoor |
4 gallons |
10 linear feet, per foot of depth |
0.05% to 0.1% |
Rod holes must be spaced in a manner that will allow for a continuous chemical treated zone, not to exceed 12 inches. When trenching, the trench along the outside foundation should be about 6 inches in width and 6 inches in depth. Use a low pressure spray (not to exceed 25 PSI at the treatment tool when the valve is open). |
voids in hollow masonry units
| Target pest |
Location |
Rate |
Unit |
Dilution |
Label notes |
| subterranean termite |
Outdoor |
2 gallons |
10 linear feet of wall |
0.05% to 0.1% |
Apply solution so it will reach the footing by injecting into the lower areas of the wall, just above the floor or footing. |
Mixing instructions 8
| For pests |
Amount |
Per |
Finished strength |
| subterranean termite |
6.3 fl. oz. |
50 gallons water |
0.05% |
| subterranean termite |
12.5 fl. oz. |
100 gallons water |
0.05% |
| subterranean termite |
25 fl. oz. |
200 gallons water |
0.05% |
| subterranean termite |
123 fl. oz. |
1,000 gallons water |
0.05% |
| subterranean termite |
12.5 fl. oz. |
50 gallons water |
0.10% |
| subterranean termite |
25 fl. oz. |
100 gallons water |
0.10% |
| subterranean termite |
50 fl. oz. |
200 gallons water |
0.10% |
| subterranean termite |
246 fl. oz. |
1,000 gallons water |
0.10% |
Use restrictions 2
- Do not formulate this product into other end-use products.
- Do not apply at a lower dosage and/or concentration than specified on this label for applications prior to installation of the finished grade.