Chemicalsclarkeanvil-10-10

Anvil 10+10

Clarke · Piperonyl butoxide 10%; Phenothrin 10% · EPA Reg 1021-1688 · INSECTICIDE; MITICIDE Document last checked 2015-09-03

About this product

Active ingredient Piperonyl butoxide 10%; Phenothrin 10%
Manufacturer Clarke
Category INSECTICIDE; MITICIDE

Full details for Anvil 10+10

Source product label ↗ Open the catalog source label while the local copy is reviewed. Verify the product name, EPA registration number, and revision before use. Source safety data sheet ↗ Open the catalog source SDS while the local copy is reviewed. Verify the exact product and revision before relying on it. EPA registration data Reg. 1021-1688 — registry reference, signal word and status.

Applicator discussion

Nothing here is label direction — the label is the law. These are notes from other applicators, moderated before they appear. Check the labeling accompanying the product and applicable state requirements.

Add your experience

Sign in through the portal or Create a free account to post. Comments are reviewed before they appear. Need a website for your pest-control business? See site plans.

According to the label From the product label

These details were extracted from this product's label PDF. The label is the law. Confirm every rate, site, restriction and safety requirement against the label before mixing or applying. Check for a state supplemental label; a product may be restricted or prohibited in a state or site even when a rate appears below. · EPA registration data for Reg. 1021-1688 →

Anvil 10+10 ULV is an oil base formulation used to control adult mosquitoes. It is applied outdoors to vegetation surrounding parks, woodlands, swamps, marshes, overgrown areas, and golf courses. Application can be done using non-thermal, portable, motorized backpack equipment or via fixed wing or rotary aircraft.

Pests covered (4)
adult mosquitoesMIDGESMOSQUITOES (ADULT)BLACK FLIES
Areas treatable (15)
vegetation surrounding parks, woodlands, swamps, marshes, overgrown areas and golf coursesAGRICULTURAL (NONCROP AREAS) (FOLIAR TREATMENT)AERIAL APPLICATIONAERIAL APPLICATION (FIXED WING)AERIAL APPLICATION (ROTARY AIRCRAFT)ULTRA LOW VOLUME APPLICATION (OIL SPRAY)RECREATIONAL AREASPARKSDOMESTIC DWELLINGS (OUTDOOR)SWAMPS (FOLIAR TREATMENT)SWAMPS/MARSHES/BOGS/STANDING WATER (VEGETATION) (FOLIAR TREATMENT)MARSHES (SURROUNDING VEGETATION-FOLIAR TREATMENT)RECREATIONAL AREAS (GOLF COURSE)WOODLANDS (PUBLIC HEALTH)MOSQUITO ABATEMENT DISTRICTS

How to treat each type of area 5

vegetation surrounding parks, woodlands, swamps, marshes, overgrown areas and golf courses

Target pest Location Rate Unit Dilution Label notes
adult mosquitoes Outdoor 0.62 Fl.oz. ANVIL undiluted using a swath width of 300 feet; vary flow rate according to vegetation density and mosquito population. Use higher flow rate in heavy vegetation or when populations are high.
adult mosquitoes Outdoor 0.42 Fl.oz. ANVIL undiluted using a swath width of 300 feet
adult mosquitoes Outdoor 0.21 Fl.oz. ANVIL undiluted using a swath width of 300 feet
adult mosquitoes Outdoor 0.21 to 0.62 fl. oz. of the undiluted spray undiluted non-thermal, portable, motorized backpack equipment; 50 ft. (15.2 m ) swath while walking at a speed of 2 mph (3.2 kph)
adult mosquitoes Outdoor 0.21 to 0.62 fluid ounces ANVIL 10+10 ULV may be diluted with a suitable solvent such as mineral oil fixed wing or rotary aircraft

Mixing instructions 1

For pests Label notes
mosquitoes ANVIL 10+10 ULV cannot be diluted in water. Dilute this product with light mineral oil if dilution is preferred.

Timing & weather

Use restrictions 5